1998 Conference Proceedings

Session 1: Low Voltage High Current DC/DC Module
1.1 : Improve Light Load Efficiency for Synchronous Rectifier Buck Converter
1.2 : The Impact of Coltage Scaling on Power MOSFET Performance in Future VRM
Session 2: High Frequency Integrated Magnetics
2.1 : Integrated Planar Inductor Scheme for Multi-Module Interleaved Quasi-Square Wave (QSW) DC/DC Converter
2.2 : Applications of Half-Turn on E-core in Switching Power Supplies
2.3 : Integrated Filter Forward Converters (IFFCs)
Session 3: Power Quality and Power Factor Correction
3.1 : IEEE and International Harmonic Standards Impact on Power Electronic Equipment Design
3.2 : Comparison Between CCM-Single-Stage (PFC) and Two-Stage Boost PFC Converters
3.3 : A New Soft-Switched Quasi-Single-Stage (QSS) Bi-Directional Inverter/Charter, Part I: Principles of Operation
3.4 : A New Soft-Switched Quasi-Single-Stage (QSS) Bi-Directional Inverter/Charter, Part II: Analysis and Hardware Implementation
Session 4: Inverters
4.1 : Fundamentals of a New Family of Auxiliary Resonant Snubber Inverters
4.2 : Comparison of Modulation Methods for Induction Motor Electric Vehicle Drives
4.3 : Modularized Control Architecture for Power Converters
Session 5: Power Electronic Building Block (PEBB)
5.1 : Active Compenstaion of the Pulsating Current in a Dustributed Power System
5.2 : Thermal Management of High-Power Electronics Modules Packaged with Interconnected Parallel Plates
5.3 : Implementation of a 100 kW Three-Phase PFC Rectifier with ZCT Soft-Switching Technique
Session 6: High Power Electronic Building Block
6.1 : An Utility Power Supply for Nonlinear and Unbalanced Load in a PEBB Based DC Distribution Power System
6.2 : A Comprehensive Study of Neutral-Point Voltage Balancing Problem in Three-Level Neutral-Point-Clamped Voltage Source PWM Inverters
6.3 : Multiple Sources in PEBB-Based DC Distibuted Power Systems
Dialogue Session
D-1 : Bi-Directional Full-Bridge DC/DC Converter with Unified Soft-Switching Scheme, Part I: Principles of Operation
D-2 : Bi-Directional Full-Bridge DC/DC Converter with Unified Soft-Switching Scheme, Part II: Design, Implementation, and Experimental Results
D-3 : Large-Signal Transient Analysis of Forward Converter with Active-Clamp Reset
D-4 : Using Simulation for Design Verification of Bias Power Supply in a DC/DC Converter System
D-5 : An Improved Three-Phase Auxiliary Resonant Snubber Inverter for AC Motor Drive Applications
D-6 : Selection of Switching Frequency for Soft-Switched Inverter on EV System
D-7 : Device Evaluation for 20kW Inverter for Hybrid Electric Vehicle Applications
D-8 : Fast VRM with High Input Voltage
D-9 : Design Optimization of an Off-Line Input Harmonic Current Corrected Flyback
D-10 : An Improved CCM Single-Stage PFC Converter with Auxiliary Switch
D-11 : A Classification and Evaluation of Paralleling Methods for Power Supply Modules
D-12 : Accurate Modeling and Analysis of PWM Inverters for Electromagnetic Compatibility Performance Evaluation
D-13 : Characterization of Power Electronics System Interconnect Parasitics Using Time Domain Reflectometry
D-14 : EMI Experimental Comparison of PWM Inverters Between Hard-Switching and Soft-Switching Techniques
D-15 : A Comparative Study of a Family of Charge Pump Power Factor Correction Electronic Ballasts
D-16 : New Charge Pump Power Factor Correction Electronic Ballast with a Wide Range of Line Input Voltage
D-17 : Design of a Novel Zvt Soft-Switching Chopper
D-18 : A Novel Soft-Switching Chopper Using Auxiliary Resonant Snubbers for a MAGLEV System
D-19 : Design Considerations of a Start-Up Process for Active-Clamp Isolated Full-Bridge Boost Converter
D-20 : Integrated EMI/Thermal Design for Switching Power Supplies
D-21 : A Thermo-Mechanical Analysis of Metal-Post-Interconnected-Parallel-Plate Structure
D-22 : Buried-Oxide Emitter Controlled Thyristor (BO-ECT) - A New MOS-Gated Thyristor with Excellent High-Voltage Current Saturation Capability
D-23 : The Dual Gate Emitter Controlled Thyristor (DGECT)
D-24 : Numerical Study of Dual MOS Gate Thyristor
D-25 : Experimental Demonstration of Bipolar Juction Diode
D-26 : New Cascade Switch Multi-Level PWM Converters
D-27 : Control Design and Implementation of Three-Level Two-Quadrant Chopper
D-28 : An Analysis of MidpointBalance for the Neutral-Point-Clamped Three-Level VSI
D-29 : Control Design for Superconductive Magnetic Storage Power Conditioning System
D-30 : Analysis of Converter Operation with Phase Control in Daisy-Chained or Ring-Type Structure
D-31 : Electromagnetic Transient Interaction of a SMES Coil and the Power Electronics Interface
D-32 : Mitigation of the Interactions between Paralleled Three-Phase PWM Boost Rectifiers
D-33 : Single Magnetic, Unity Power Factor, Isolated Power Converter with Ripple Free Input Current